HR0214-71A FLOW SENSOR 3/4 BRASS MATERIAL 60mm cable, YF-B6

Working principle: 

When the water flows through the rotor, then rotor is rolled.Its speed changes with different rate of flow. Then the magnetic rotor make reaction to Hall sensor,The hall-effect sensor outputs the corresponding pulse signal .The flow sensor is suitable to detect the flow rate.

 

Specification : 

Thread size :DN20, G3/4” (BSP) , male.

Flow hole: 14mm (diameter)

Voltage: DC4.5-18v

Body Material: brass 

Flow rate : 2~45L/min

Flow Pulse:  F(Hz)=8.1*Q – 3(+/-10%)    Q=L/min

Max. Working Current : 10mA (DC5 V)

Min. Working Voltage: DC 4.5V

Working Voltage: DC 4.5V~18V

Load Capacity: =10 mA (DC 5 V)

Insulation resistance: over 100M Ohm 

Max pressure: 1.75mpa

Suitable for liquid : water.(less than 60 cel. degree)

 

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: